Shipping within 24-72h*
100% Money Back Guarantee
30 days return policy
Shop By Categories
Power Supply 750W No-Modular 80+ Certified,Desktop Computer ATX Smart Power Supply With 120mm Ultra Quiet Auto Speed Control Fan,6 protection functions , 10 Year Warranty

Power Supply 750W No-Modular 80+ Certified,Desktop Computer ATX Smart Power Supply With 120mm Ultra Quiet Auto Speed Control Fan,6 protection functions , 10 Year Warranty

BrandsZERTONE
Product Code:
SKU : 9SIAP7MC8M2750
Product available in stock : 94
  • 149€


Free shipping from € 1000,- order value
Shipping within 24-72h*
30 Day Money Back Guarantee

Product Bullets

  • 6 protection function (over-left OCP, over-temperature OTP, overpressurized OPP, under-pressure UCP, over-power OPP, short circuit SCP)
  • Support for backlines You can use large chassis backlines
  • Strengthen 12V professional optimization of graphics card power supply
  • A 120mm low-noise cooling fan with a specially designed fan curve spins at higher speed when your power supply is under heavy load and slows down for quieteroperation at lower loads.

Product Info















Specifications:

High-end wire configuration:

Motherboard power supply interface: 20+4P*1

CPU-powered interface:1*4+4p

Graphics power supply interface: 2*6+2p

Hard drive power interface: SATA*3

Hard drive fan power interface: IDE*2

NOTE:

1. The continuous total max. DC output power shall not exceed 750W, +3.3V and +5V,combined continuous output power not exceed 100W Max

2. +12V and +5VSB peak surge current 16sec. max.

3.A 0.1uF and 10uF tantalum capacitors should be put across output terminals during ripple & Noise test. The oscilloscope bandwidth is set at 20 MHz and co-axial probe will be used to measure it.

4.The cross-load regulation in defined in the matrix below.(UNIT: A )

PROTECTION :

If the power supply is latch into shutdown stage (when OCP ,OVP or short protection is working ),the power supply shall return to normal operation only after the fault has been removed and remote signal must reset for a minimum of 1 second(or the AC removed for 10 second) . Then ,it will turn on again .



AUXILIARY +5Vsb

This power supply is specifically equipped with an independent stand-by +5V output current , 2.0A max . This output will always provide +5v except when the AC line is cut-off .

HI-POT

7.1 INPUT TO GND : VOLTAGE 800VAC TIME 2.0~3.0 SEC. CUT OFF CURRENT 10mA MAX

EARTH CONTINUITY TEST : 100mO MAX at 25.0A .

LEAKAGE CURRENT EACH LINE TO GND.

3.5mA MAX. AT 264V 50Hz



ENVIRONMENT :

AMBIENT OPERATION TEMPERATURE 5° to +40°

AMBIENT OPERATION RELATIVE HUMIDITY 20% to 85%

AMBIENT STORAGE TEMPERATURE - 40° to +55°

AMBIENT STORAGE RELATIVE HUMIDITY 10% to 95%

SPEC SIZE:

SHOW SIZE:150*140*86MM



CASE STRUCTURE MACHINERY:I/O INLET+OUTPUT 120mm FAN
Additional Information
Date First Available September 22, 2020
Details
+12V Rails 3
Connectors 1 x 24 pin (20+4) ATX
CrossFire Yes
Efficiency > = 65%
Energy-Efficient 80 PLUS Certified
Fan LED RGB
Fans 1
Hold-up Time 16.6ms min.
Input Frequency Range 47 - 63 Hz
Input Voltage 110 - 240 V
Main Connector 20+4Pin
Maximum Power 750 W
Modular Non-Modular
Over Voltage Protection Yes
Overload Protection Yes
PCI-Express Connector 2 x 6+2-Pin
PFC No
Power Good Signal 100-500ms
SATA Power Connector 3
SLI Yes
Type ATX
General
Series Fatal1ty
Connectors
Main Connector 20+4 Pin
SATA Power Connector 3
Output
+3.3V Max. Current 25A
+5V Max. Current 25A
+12V1 Max. Current 19A
+12V2 Max. Current 19A
+12V3 Max. Current 18A
-12V Max. Current 0.8A

Write a review

Note: HTML is not translated!
    Bad           Good